As some of you may know from the Cana thread I had to return mine due to an 'on going fire issue'.
@Cape vaping supplies was able to organise me a replacement, and was not required to send my old one in - he had tried to fix it, but it was not possible.
When he shipped my new one to me, I asked him to ship me the carcass of my first unit, so I could fiddle with my SX350.
I present to you, Project Canax350....
1. Material removed from the case to fit the SX350 screen
2. SX350 in place, with 18650 in sled. Tight fit, but no need to cut into case. Just needed to trim a tiny bit of glue off each side of the SX350 chip
3. The SX350 chip showing through the window - rough cut out.
4. Powering up the SX350 - Hello YH!
5. Better view of the screen
6. SX350 Logo!
7. Another view of the window after first run with a cutting wheel on my fDremel
8. Window tidied up
I finished off the window with a file, to get everything much cleaner.
Next up I need to find a few square centimetres of one-way film, to place in the perspex piece I have to go between the window in the case and the SX350.
Not sure where I will find that, and I have a busy week coming up, so will be a while before I can get back to this
@Cape vaping supplies was able to organise me a replacement, and was not required to send my old one in - he had tried to fix it, but it was not possible.
When he shipped my new one to me, I asked him to ship me the carcass of my first unit, so I could fiddle with my SX350.
I present to you, Project Canax350....
1. Material removed from the case to fit the SX350 screen
2. SX350 in place, with 18650 in sled. Tight fit, but no need to cut into case. Just needed to trim a tiny bit of glue off each side of the SX350 chip
3. The SX350 chip showing through the window - rough cut out.
4. Powering up the SX350 - Hello YH!
5. Better view of the screen
6. SX350 Logo!
7. Another view of the window after first run with a cutting wheel on my fDremel
8. Window tidied up
I finished off the window with a file, to get everything much cleaner.
Next up I need to find a few square centimetres of one-way film, to place in the perspex piece I have to go between the window in the case and the SX350.
Not sure where I will find that, and I have a busy week coming up, so will be a while before I can get back to this
Last edited:
