Bumpedy Bump - Vape Mail!
- Thread starter Gizmo
- Start date
Finally, the 3 month wait is over
3 months is a veeeeeeeeeery long wait!
Straight from Renova in China
32 Flavors, Nic Salt, PG and VG
Excellent @Juan_G. Out of curiosity, what tank are you planning on using now that your JKM and X are sold?It has finaly arrived
It has finaly arrived
Welcome to the Club!
The Renovo Pod is a very good system, one of the pods that actually has good flavour and coils that last a reasonable amount of time.
Last edited:
Have you thought of a heat sink that will fit the Pico, is 22 non though, so tank overhand slightly on that but it’s a workable option. Use mine to get a 24 mm Avo 24 on there.
I have only seen positive reviews so far
so far I like it a lot
Pick up vapemail from @Room Fogger Great meeting you today Sir, thanks for the chat and arranging these goodies 
Using my dead rabbit and gear until the Fatality's land.
I have one of those 22mm heat sinks, not my ideal solution as I don’t like RTAs that are to tall on my Pico. Reckon I will rather source the Wasp RDTA as it’s atleast a 22mm tank.
That MTL Staple intrigues me @Grand Guru
@Paul33 The Coilology Staple MTL wire is not bad, also wanted to try it as I use Vandy Vapes Ni80 MTL wire plus it is cheaper. I would say from vaping both that they are about the same with flavour.
The Coilology wire builds a lot lower than the Vandy Vape for example 2.5mm Coil with 6x Wraps is 0.55ohm with Coilology and 0.75ohm with Vandy Vape, something to consider.
I picked up some Geekvape Tri Core Fused Clapton MTL Wire today (Ni80 30g*3+38g). This wire is a little thicker than the other two MTL wires and also builds low on same size coil as above spec at a 0.50ohm build.
I like this Tri Core Geekvape wire, flavour is better than the other 2 MTL wires but the coil is slightly fatter and does not fit my Dvarw MTL. Fits fine in the Skyline and Vapefly Galaxies RDTA, going to do a 8x Wrap 2.5mm 0.65ohm coil and try it out.
That sounds like it would be a nice build for the Exocet...
It’s perfect for the Exocet. Vapers Corner has this wire. Check it out, I’m well impressed, my Skyclone is vaping like a dream with this coil wire.
Last edited:
I’m still looking for the perfect MTL setup, I guess. A nice opportunity to experiment new stuff every week
Similar threads
