*Tips and tricks*
You can use 2 magnets and increase field strength by adding a nylon washer under the bottom Magnet. I used a 2mm washer. This will keep the switch feel light but support the heaviest tanks.
You are simply bringing the magnets closer together Before Firing.
No need to open the center hole in the magnets. Magnets stay below the pin once everything is assembled. The pin stays in alignment with the Delron section and acts as a lock to keep the button from free spinning.
Remove pin........if it hasent fallen out while disassembling. Install magnets reassemble everything without the springs.
You can use 2 magnets and increase field strength by adding a nylon washer under the bottom Magnet. I used a 2mm washer. This will keep the switch feel light but support the heaviest tanks.
You are simply bringing the magnets closer together Before Firing.
No need to open the center hole in the magnets. Magnets stay below the pin once everything is assembled. The pin stays in alignment with the Delron section and acts as a lock to keep the button from free spinning.
Remove pin........if it hasent fallen out while disassembling. Install magnets reassemble everything without the springs.