Recent content by ihaveacharredwick

Ok. I will after this bottle is up. I wonder if widening the air hole will help. Thanks for the help Meneer Odenkirk. Btw really enjoying 0.8. Don't think I could go much lower though.

No I mean like really hot. I have a delrin tip so it's not a problem, but after a few hits I can't even rest my finger on the atty. I thought these ones didn't get hot. Although I never understood that statement - "such and such atomizer doesn't get hot" - doesn't it solely depend on the build...

It helped. Vape is quite nice. I tried at .8 ohms with 27g and a 2mm diameter (will try get closer to your exact setup later when I have what I need). Only thing is now the reomizer gets massively hot. Is this normal? At 1 ohm / 28g / 1.5mm it didn't.

No you've provided super info here. I'm going to be trying this for sure. Thank you sir. Why would .8 be better for the wick that 1.0? Is it particularly because of your method of thicker gauge/diameter + less wraps?

Yep. And an overdraft! And a charred wick.

Righto. Thanks a lot. Strange because I keep it well juiced before firing it and I've tried thin wicks too :( I am quite new to rebuildable atomizers though. I'm used to using cartomizers and such. Thanks very much for the help.

So you think the tiny coil isn't allowing for juice flow? Would spacing it out help as well?

It's a dibi/oliver bottom fed mechanical mod and the atomizer is a reomiser 2. But this happens with other setups as well. Driving me crazy. I think I might need to switch to another type of wick.

I use KGD cotton inside micro coils. 1.5mm diameter, 28g wire, about 1ohm. And after 3mls - 6mls it starts getting dark. Why is this happening? It happens with unflavoured juice, and however thin or thick I make the wick. Also it only happens where the coil makes contact with the wick. When I...