Its not a myth, but not sure when its coming though. Confirmed this with Voopoo
As long as it's coming I'm happy
Now all I need is patience!
I’m sure it’ll SOON be available in SA
https://www.ecigssa.co.za/this-is-for-you-original-voopoo-vinci-x-pod-kit.t63638/
https://www.ecigssa.co.za/this-is-for-you-original-voopoo-vinci-x-pod-kit.t63638/
Voopoo actually announced the release of the RBA yesterday
Has anyone built and (successfully) wicked one of these?
In my 5 attempts I could not get it right. I either get no airflow (too thick wicking) and dry hits or it just leaks! I've given up on it.
In my 5 attempts I could not get it right
. I either get no airflow (too thick wicking) and dry hits or it just leaks! I've given up on it.
It's a pain!Has anyone built and (successfully) wicked one of these?
In my 5 attempts I could not get it right
I've given up on it and eventually bought RTA pods for my wife and I. For me it works well but my wife prefers a MTL vape, it would be ideal to have the RBA coil in the MTL pod in her Drag S.
I simply gave up pods all together. I don’t believe it’s worth it with all the plethora of RTAs out there.
Has anyone got this right yet?
My wife's gotten back into MTL vaping and the MTL VooPoo PnP coils don't last very long (when compared to the 0.15 and 0.3 ohm coils). This would be ideal, if I figure out how to get it right.
My wife's gotten back into MTL vaping and the MTL VooPoo PnP coils don't last very long (when compared to the 0.15 and 0.3 ohm coils). This would be ideal, if I figure out how to get it right.
If she is into MTL/RDL, keep your sanity and get her an intake MTL. It’s satisfaction guaranteed!
I have the MTL pod for her DRAG as well as the RBA deck already so I may as well try and get it right. I'm trying not to spend any more money on vape stuff for a while.
If unsuccessful, I may have to look at a MTL tank and the 510 adaptor for her Drag.
What are you struggling with? I have had mine a long time and love it!
Wicking it mainly, I cannot get the wicking right for the bloody thing - either dry hits or leaks.
Ok, what I do is wet it with juice and mold it into the juice channels, this is with a 2mm 26g wire coil. After molding its easy to see how much cotton is extra and simply cut it off , then mold it again so it sits properly in the slots, it should be enough that it is flush with the screw threats or slightly over flush. When screwing on the cap, make sure you don't have cotton between the threads, and that should work great.
Similar threads
