For those of you who own an IGO-L original or Clone. I see there are quite a few of them on the forum.
I had a problem a while back with the cap sitting too loose.
I came across a solution for fixing it. The most obvious is trying to get some new O-rings.
Another solution that worked for me was to remove the bottom O-ring and add one wrap of dental floss around the O-ring groove. Then carefully replacing the O-Ring on top of the layer of floss. This lets the bottom O-ring stand out just enough to make it sit a bit tighter (and smell minty fresh). Remember to tuck away the tips under the O-ring.
If it is still too loose do the same to the top O-ring. The same goes for any drip tip that sits too loose.
Hope this helps someone.
I had a problem a while back with the cap sitting too loose.
I came across a solution for fixing it. The most obvious is trying to get some new O-rings.
Another solution that worked for me was to remove the bottom O-ring and add one wrap of dental floss around the O-ring groove. Then carefully replacing the O-Ring on top of the layer of floss. This lets the bottom O-ring stand out just enough to make it sit a bit tighter (and smell minty fresh). Remember to tuck away the tips under the O-ring.
If it is still too loose do the same to the top O-ring. The same goes for any drip tip that sits too loose.
Hope this helps someone.
Last edited:
