Russian 91%
- Thread starter Rob Fisher
- Start date
yussis and i was in checkers over the weekend
ill have to make a way to get there again soon
thanks @Hein510
thats the exact one i was looking for
Anyone in CT can get them from R James Hardwear in Wynberg.
Tighten the screw at the very bottom of the Russian at the connection. It threads up in the juice hole. Be careful, easy to break if you overtighten.
guys, i need help asap please.
i wanted to be brave and try this filling from the top thing.
i kept my finger on the airhole as i removed the top cap, filled and then closed again.
im getting heavy gurgling and now the juice is p!ssing out of the airhole and air control screw.
what did i do wrong?
how can i fix it? (without loosing all my juice)
i wanted to be brave and try this filling from the top thing.
i kept my finger on the airhole as i removed the top cap, filled and then closed again.
im getting heavy gurgling and now the juice is p!ssing out of the airhole and air control screw.
what did i do wrong?
how can i fix it? (without loosing all my juice)
Sounds like there is juice in the center pin, just below the coil. Try blowing a tiny amount through the drip tip, it may push the juice down the pin to the airhole, and then you can "sneeze" it out.
Also, check the cavity just below the driptip. Sometimes that gets a little juice or condensation in it.
I keep a blunt needle and syringe at home for extracting juice when things like this happen.
Stay at it with the top fill method, it does work but is unreliable
Also, check the cavity just below the driptip. Sometimes that gets a little juice or condensation in it.
I keep a blunt needle and syringe at home for extracting juice when things like this happen.
Stay at it with the top fill method, it does work but is unreliable
not sure on the fix while it is full but when filling as you have described, once you have closed the top again flip the russian over before releasing your finger from the air hole. This works on the kayfun. I haven't had a single leak since I started using this method.
does anyone else have this problem:
when the russian stands for a little bit (like 2 minutes) and i pick to vape, i get a gurgle on the first pull.
i normally just pull a small puff, then after that she hit like a train and doesnt gurgle at all.
what causes that initial gurgle?
how can it be eliminated?
when the russian stands for a little bit (like 2 minutes) and i pick to vape, i get a gurgle on the first pull.
i normally just pull a small puff, then after that she hit like a train and doesnt gurgle at all.
what causes that initial gurgle?
how can it be eliminated?
Are you topping up or filling from empty?
With my aqua I use to get that but what I do is fill it, then screw the top cap on just enough so that the top cap doesnt come off, turn it upside down then tighten, I do all this while the air holes are closed, keep it upside down for about 30secs then open the air holes with it still upside down for a further 30secs, then fire it while upside down for a second then turn it over.
Hope that helps.
i fill mine from the bottom screw though
so i unscrew it from the mech, turn upside down, unscrew and fill
at which point should i do what you suggested?
I wouldnt fill it from the bottom when topping up because of the air pressure that already exists in the tank.
If you are filling from empty then filling from the bottom is fine.
In both cases the method I described above should work.
If you are filling from empty then filling from the bottom is fine.
In both cases the method I described above should work.
Yeah, close the air hole tight, open the top cap for 30secs, then follow the method above.. should help
Similar threads
