Scdrl clone help needed

[Vape0206]

Hi all

So i just bought a scndrl clone mech and i have a bit of a problem. My limitless 24 rda wont screw down into the tube with hybrid connector. Its actually just the topcap that lifts. I was thinking of maybe putting something underneath the copper contact inside the mod which will maybe lift the battery a bit? If anyone had an issue like this or knows how to fix it please advise.

TIA

Sent from my ALCATEL ONE TOUCH 6032 using Tapatalk

 

[Dubz]

You have to remove the hybrid topcap from the mod. Screw the topcap onto your RDA, then screw RDA with topcap onto the mod.

 

[Vape0206]

You have to remove the hybrid topcap from the mod. Screw the topcap onto your RDA, then screw RDA with topcap onto the mod.

I did that.. But the battery sits to low so i need to screw it further into the mod tk make connection.. I'll try to take a pic

Sent from my ALCATEL ONE TOUCH 6032 using Tapatalk

 

[Dubz]

Ok i see what you mean now. In the video below the guy puts the switch back after taking it apart it seems you might be able to put a spacer of some sort onto the shaft of the switch. Perhaps under the magnets.

 

[Vape0206]

Thanks man but the video eint showing

Sent from my ALCATEL ONE TOUCH 6032 using Tapatalk

 

[Vape0206]

Should the spacer be of a specific material?

Sent from my ALCATEL ONE TOUCH 6032 using Tapatalk

 

[Dubz]

Here is a guy that has some fixes for your issue...

 

[Vape0206]

@Dubz a huge thank you man for that video

Sent from my ALCATEL ONE TOUCH 6032 using Tapatalk

 

[Dubz]

@Dubz a huge thank you man for that video

Sent from my ALCATEL ONE TOUCH 6032 using Tapatalk

All good.