So I have this cool stainless driptip I acquired recently, only problem was getting a snug fit in any of my devices.
I tried swopping O-rings with some of the other tips on hand, but none of them fitted quite well enough. So I cut a small piece of electrical tape, and then cut a thin section about the same width as the existing o-ring, carefully wrapped it into and around the o-ring groove. And finally fitted the original ring back into place.
The end result being a perfectly snug fit on the kayfun, and Trident.
I tried swopping O-rings with some of the other tips on hand, but none of them fitted quite well enough. So I cut a small piece of electrical tape, and then cut a thin section about the same width as the existing o-ring, carefully wrapped it into and around the o-ring groove. And finally fitted the original ring back into place.
The end result being a perfectly snug fit on the kayfun, and Trident.