Tita AIO

[DanielDC13]

Hi there my tita AIO has a problem. I have it on 34watts but when I vape it Vapes at higher wattage. Doesn't show on the screen but u can hear the coil and is warm vape. Any idea what it can be

 

[Akil]

I had this issue on the Tita X Aio.
There was a connection issue at the flush nut, causing incorrect ohm measurements.
Try using a longer flush nut. It should sort out the problem.

 

[DanielDC13]

I had this issue on the Tita X Aio.
There was a connection issue at the flush nut, causing incorrect ohm measurements.
Try using a longer flush nut. It should sort out the problem.

Thank U so much ill try it

 

[PuffingPete]

Thank U so much ill try it

He’s talking about the boro one, not the dot one

 

[DanielDC13]

Ok but my resistance is also jumping around

 

[PuffingPete]

Dot doesn’t bridge with the top flush nut. The connection is spring loaded at the bottom. Negative in the middle and positive on the outside I think

 

[DanielDC13]

Dot doesn’t bridge with the top flush nut. The connection is spring loaded at the bottom. Negative in the middle and positive on the outside I think

Thanks Pete I'll have a look

 

[KAPOW]

Hi there my tita AIO has a problem. I have it on 34watts but when I vape it Vapes at higher wattage. Doesn't show on the screen but u can hear the coil and is warm vape. Any idea what it can be

Check your build. Make sure post screws are properly tightened and RBA airflow pin is fully seated.

 

[DanielDC13]

Ok, thank you very much.

I'll check it and see if everything is connected properly.

Yeah, thank you very much.

Check your build.

Make sure post screws are properly tightened and RBA airflow pin is fully seated.