DIY Clear Vape Bands (Thin-Wall Upgrade)
Putting new custom vape bands on my 26mm tanks.
Just to clear something up from an earlier thread—someone thought I was just trying to be a skinflint making my own bands, which completely missed the point. Standard silicone bands and tank cages block too much of the glass. Making them from clear PVC gives 100% unobstructed visibility of your e-liquid level while still protecting the bubble glass from knocks.
Ages ago I could only source thick-walled clear PVC tubing. It did great service for about 3 years—yellowed slightly over time, though the juice remained completely visible—but added a fair bit of bulk. I’ve now found thin-walled clear PVC tubing (25mm ID), which is literally half the wall thickness of the old stuff and hugs the contour of the bubble glass cleanly once softened in boiling soapy water and trimmed to fit.
Photo 1: Fitted on the blue RTA—logo and liquid level completely visible.
Photo 2: Side-by-side comparison of the new thin-wall bands against the older, slightly yellowed thick-wall bands.
Photo 3: Trimmed off-cut showing the thinner wall profile.
Photos 4 & 5: Three spare bubble glasses sleeved and bevelled ready to go.




Putting new custom vape bands on my 26mm tanks.
Just to clear something up from an earlier thread—someone thought I was just trying to be a skinflint making my own bands, which completely missed the point. Standard silicone bands and tank cages block too much of the glass. Making them from clear PVC gives 100% unobstructed visibility of your e-liquid level while still protecting the bubble glass from knocks.
Ages ago I could only source thick-walled clear PVC tubing. It did great service for about 3 years—yellowed slightly over time, though the juice remained completely visible—but added a fair bit of bulk. I’ve now found thin-walled clear PVC tubing (25mm ID), which is literally half the wall thickness of the old stuff and hugs the contour of the bubble glass cleanly once softened in boiling soapy water and trimmed to fit.
Photo 1: Fitted on the blue RTA—logo and liquid level completely visible.
Photo 2: Side-by-side comparison of the new thin-wall bands against the older, slightly yellowed thick-wall bands.
Photo 3: Trimmed off-cut showing the thinner wall profile.
Photos 4 & 5: Three spare bubble glasses sleeved and bevelled ready to go.



